![]() So if you have only iBeacon enabled, and an advertisement rate of 10Hz, then the beacon's overall advertisement rate is 10Hz. The effective overall advertisement rate is therefore the number of advertisement types enabled multiplied by the advertising rate. The value shown is the advertisement rate for EACH advertisement type. The slider displays a value of 1-10Hz, or 1-10 advertisements per second. You can modify the advertising rate by moving the slider control in the ADVERTISING RATE section. If you need to determine the Measured Power value for your beacon, follow the steps outlined in the article, RadBeacon App - Calibrating a Beacon's Measured Power) 41 dBm is the characteristic signal loss over 1 meter. (A rule of thumb is to determine the iBeacon/AltBeacon measured power value and then add 41dBm to it. Calibrated Power - The transmit power as measured zero (0) meters away from the beacon.(Note that due to the manner in which the Eddystone URL is encoded and stored, it is difficult to predict whether a URL will fit in the available advertisement payload space, so you should always verify your URL advertisements after saving.) In this section, specific the following values With the Eddystone URL advertisement type enabled, you can make changes to the Eddystone URL advertised values under the section labeled EDDYSTONE URL. Setting the Eddystone URL Advertisement Values If you need to determine the Measured Power value for your beacon, follow the steps outlined in the article, RadBeacon App - Calibrating a Beacon's Measured Power ) Instance ID - A 6-byte hexadecimal unit identifier.Namespace ID - A 10-byte hexadecimal organizational identifier.With the Eddystone UID advertisement type enabled, you can make changes to the Eddystone UID advertised values under the section labeled EDDYSTONE UID. Setting the Eddystone UID Advertisement Values To save these and other changes to the beacon, tap on the Actions menu and select the Apply action to submit your changes to the beacon along with a valid PIN. (If you need to determine the Measured Power value for your beacon, follow the steps outlined in the article, RadBeacon App - Calibrating a Beacon's Measured Power) Measured Power - The transmit power as measured one (1) meter away from the beacon. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |